This is a Preowned Milwaukee Hacksaw 2520-20 with Battery & Charger . In good working condition does show some signs of usage. Tested works just as intended.

This is a Preowned Milwaukee Impact Wrench with Battery . In Good Condition Works jus as Intended. Does show some signs of Lite Usage. Tool and Battery Only.

Tools Wrench Milwaukee 2922-20 with 6 dies 

Tools

Milwaukee M18 FUEL 2-Tool Kit 3697-22 Hammer Drill & Impact Drive

Includes:

1 x 1/2in Hammer Drill / Driver 

1 x 1/4in Hex Impact Driver

2 x M18 REDLITHIUM XC 5.0Ah Battery

1 x Charger 

1 x Hard Carrying Case

Tools Other Snap On CJ2001p complete set

Tools Drill Dewalt DW272 VSR Drywall Screwgun no box in fair condition

Tools Other Dewalt DXPA37SC Pressure Washer Surface Cleaner lnib

These are Preowned Porter Cable - PCC641 Impact Driver  - PCC601 Drill  - PCC661 Circular Saw  3 pc set tools only. All in working condition but do show wear.  All have been tested before listed.

This is a Preowned Ridgid Brushless 18V 4 1/2" Grinder with Wheel Model R86041. Cjomes with the  Battery & Charger . Does show signs of usage. Works with no issues.

This is a preowned DeWalt Cordless Oscillating Multi-Tool DCS355 w Battery & Charger , In Good Working Condition does show signs of usage.

This is a preowned Driver with the Charger and a 20v Battery. Does show signs of usage but works just as intended.

Tools Drill Milwakee 3453-20 with battery and charger 

Tools Stapler Milwaukee 2447-20 3/8 crown stapler SPB JA 358006 WITH ONE BATTERY used condition slight scuffs on top and rubber fittings throughout, no charger.

Tools Drill Dewalt DCF887 3-Speed Brushless 20V Max Cordless 1/4" Impact Driver with battery and charger .  Works as intended  does show signs of usage .

Unopened Unused Diablo Tools 6in Steel Demon Carbide Blades for Thin Metal Conduit Cutting 3pk.

This is a preowned kit that is in extremely good condition does show some wear. Some General Information listed below not all may apply...                                  

Manufactured by Waekon, part number 46568.

Complete EVAP System Leak Diagnosis in Minutes!


VERIFY the Leak, PINPOINT the Leak, VERIFY the Repair. No long waiting time for OBDII EVAP monitors to reset. No comebacks.


One of the most common reasons for a vehicle's OBDII system to set a DTC (diagnostic trouble code) is an EVAP system leak. Without the proper equipment, troubleshooting the DTC can become difficult and time consuming. The Waekon 46568 EVAP Leak Test Master Kit is the most comprehensive and cost effective means of troubleshooting EVAP leak DTCs on the market today.

The Waekon 46568 will test the entire EVAP system for leaks within in a few minutes. The EVAP pressurization manifold quickly verifies the presents of a leak in the fuel tank, EVAP lines or carbon canister. It also helps pinpoint the leak's location. In addition to the EVAP pressurization manifold, the kit includes a fuel cap tester specifically designed to determine if the fuel cap is the cause of an OBDII EVAP code.

1.) The Pressurization/Test Manifold  - a portable, self contained hand held unit designed to check the vehicle EVAP system's ability to hold pressure. Monitor system pressure and pressure decay on the precision gauge, or use the pressure manifold to maintain system pressure while pinpointing a leak source.


Can be used for complete EVAP system testing
Used to perform factory shop manual testing and diagnosis
Uses the shop air line, a portable compressed air tank, or a compressed nitrogen tank (preferred) to pressurize the EVAP system to test for leakage
Connects directly to the vehicle EVAP service port or to the universal filler neck adapter


2.) The OBDII Fuel Cap Tester  - a portable, electronic, self contained hand held unit designed to check the vehicle fuel cap's ability to hold pressure. A female quick disconnect coupling allows changing of cap adapters, and provides updating the tester as new adapters are needed.


Quickly verifies the fuel cap as the cause of an OBD II "check engine " light on
Verifies the cap will pass an emission inspection test


 

3.) Universal Filler Neck and Fuel Cap Adapters  - Covers ALL foreign and domestic OBDII vehicles.

4.) Diagnostic Manual  - Comprehensive Instruction and Diagnostic Manual.

Not sure all bits are Freud (in the box) pluse comes with all the loose bits shown in the pictures (Not sure the make on all the loose bits).... What you see is exactly what you will receive...

Tools Sander Milwaukee 2438-20 w/ charger and 1 3ah battery

This is a Preowned Milwaukee 2663-20 1/2 in. Impact Wrench Cordless M18 18V Lithium-Ion

IN GOOD CONDITION IN GREAT WORKING CONDITION

Has Some Scratches On It normal wear signs

 Milwaukee 1/2 in. Impact Wrench + Milwaukee M18  3.0 Battery -Milwaukee M12 & M18 Battery Charger

Features 450 ft. lbs. of torque to perform a wide range of fastening applications

Delivers 2200 impacts per minute for powerful performance

Features a robust design combined with rare-earth magnets for longer life, more power and more run time than any brushed competitor

Variable speed trigger provides up to 1900 RPM

Tools Drill Milwaukee 2401-20 charger 3 ah and 1.5 ah battery like new condition

Tools Drill Milwaukee 3404-20 charger 4 and 3ah batteries in great condition